Amiga Hardware DatabaseHersteller PreVue Technologies, USA | Amiga A2000, A3000, A4000 | Schnittstelle RGB-Port |
- allows the use of multisync monitors while the Amiga is in genlock mode
- in genlock mode the horizontal and vertical sync signals are set to 7.8 kHz on the Amiga video port - these signals are not used by single scan monitors, but are required for multiscan monitors
- when the Sync Strainer senses a genlock condition (as when the Video Toaster is started), it creates new H- and V-sync's from Composite sync
- acts as a simple buffer for H- and V-sync when the Amiga puts out 15.7 kHz or 31.4 kHz horizontal scan rate
- automatically switches between the various scan modes
- a 2" × 3" × 1/2" module which connects to the 23 pin RGB connector
- available with DB9 or DB15 VGA output connectors
- works with any genlock which does not use the 23 pin RGB port
- the Sync Strainer is not a scandoubler, the analog RGB signal is passed through unchanged
Gehäuse, Oberseite
Gehäuse geöffnet, Oberseite
- SyncStrainer.pdf
user manual
19 kB