|
Picasso IV |
 |
 |
 |
Company Village Tronic, Germany | | Date 1996 | | Amiga A2000 A3000, A4000
| - - | Interface Zorro II Zorro III
| | Autoconfig ID 2167 / 21,22,23,24
|
|
RTG graphics card
- Cirrus Logic GD5446 (PCI bus)
- 64 bit blitter
- 180 MB/s fillspeed
- videoscaling with interpolation
- colourroom converting
- picture in picture
- 16 bit digital video port
- 135 MHz in 8 bit modes
- 85 MHz in 16 / 24 bit modes
- 15.5 - 84 kHz horizontal frequency
- 50 Hz interlace - 160 Hz non-interlace vertical frequency
- 4 MB 64 bit 45 ns EDO RAM, eight chips
screen modes
- 1600×1200×16 interlace
- 1280×1024×24 non-interlace
integrated flicker fixer
- programmable up to 160 Hz
- 24 bit colourdepth for A4000, 12 bit for A3000 / A2000
- EPROM stores the configuration
- does not pass through native Amiga multiscan and double modes
optional modules
- Pablo IV video encoder (
)
- S-VHS and CVBS outputs
- supports PAL B/G, PAL I, PAL M, NTSC, NTSC-EIA
- SECAM is not supported
- linear interpolation reduces flickering
- two display sizes: 640×480 and 800×600 - the latter is only available in PAL B / G / I mode
- a time base corrector is required if used with a genlock
- Paloma TV tuner (
)
- three video sources - TV tuner, S-VHS, FBAS
- the tuner supports only PAL B/G or PAL I, it does not support SECAM and NTSC
- the videodecoder supports all standards, so it would be possible to use SECAM or NTSC through the S-VHS or Composite input (using a VCR as external tuner), but...
- the software (PalomaTV) is written PAL only
- monoaural sound decoding only
- no teletext support
- Concierto sound module (
)
- Yamaha OPL3 synthesizer
- 16 bit recording and playback
- 3-44.1 kHz input and output
- MIDI interface
- consists of a main board and an I/O board
- two mini DIN connectors with adaptor cables
- planned modules
notes
- Zorro II / III autosensing
- integrated local PCI bus
- flashROM for firmware upgrades
- four channel audio mixer on board: Amiga, line, TV, CD
- audio signal switcher - Amiga and CD-ROM inputs
- DDC2B Monitor Plug'n'Play technology
- DPMS power saving
- 15 pin VGA output
- S-VHS input / output for Pablo IV
- 3.5 mm stereo input / output
- when fitting into an A2000 the flicker fixer must be removed by breaking the card - requires the Denise adapter to avoid this
- no support for draggable screens
- Picasso96 and CyberGraphX 3 & 4 drivers
- supported by Linux and NetBSD
Photo
|

Rev 1.2N, front side

Rev 1.2, front side
|

Rev 1.2N, back side
|
|
|