Hypercom Plus Company VMC Harald Frank, Germany   Date 1998   Amiga A1200 A2000, A3000, A4000   - - Interface clock port Zorro II   Autoconfig ID 5001 / 6,7 serial and parallel interfaces Hypercom 3 Plus available in both Zorro II and clock port versions the latter connects directly to the 26 pin expansion port of Buddha/Catweasel or connects with a cable to A1200's clock port the Zorro II version is based on the HyperCom 4 Plus, it uses the same PCB Exar 16C552 UART chip one DB25 bidirectional parallel port with 500 kB/s transfer speed one DB9 and one DB25 RS232 serial port with up to 460800 bps transfer speed 32 byte FIFO buffer (16 byte receive, 16 byte send) not compatible with Mikronik towers supported by NetBSD Hypercom 3 Tel expansion module for the ISDN Blaster Exar 16C552 UART chip two DB25 460800 bps buffered serial ports one DB25 500 kB/s buffered bidirectional parallel port one handset connector 32 byte FIFO buffer (16 byte receive, 16 byte send) Hypercom 4 Plus Zorro II two Exar 16C552 UART chips four DB25 or DB9 RS232 serial ports with up to 460800 bps transfer speed two DB25 500 kB/s buffered bidirectional parallel ports 32 byte FIFO buffer (16 byte receive, 16 byte send) up to five Hypercom 4 can be installed into one Amiga supported by NetBSD Photo Zorro II version, back side Clock port version, front side Clock port version, back side Zorro II version, back side Software hypercom298.lha (712 kB) HyperCOM installation   VMC Harald Frank