Amiga Hardware DatabaseSearch Result
4 expansions found
Manufacturer Great Valley Products, USA | Date 1992 | Amiga A2000 | Interface CPU slot | Autoconfig ID 2017 / 11 |
- processor
- 68EC030 @ 25 / 40 MHz or 68030 @ 50 MHz, PGA
- 68882 @ 25 / 40 / 50 MHz, PGA - clocked at the same speed as the 68030
- memory
- 25 MHz: 1 MB on board + three SIMM sockets gives 13 MB max
- 40 / 50 MHz: 4 MB on board + three SIMM sockets gives 16 MB max
- supports only special 64 pin 1 or 4 MB 60 ns GVP SIMMs
- maximum 8 MB is autoconfigured in the 16 MB address space, the exact amount is set by jumper
- the remaining memory is configured as extended memory by the FaaastROM driver
- Impact Series II SCSI controller
- 1.2 MB/s transfer speed
- direct DMA transfer to onboard Fast RAM
- FaaastROM SCSI driver (gvpscsi.device) - auto booting requires at least Kickstart 1.3
- DB25 external connector
- 50 pin internal header
- supported by Linux and NetBSD
- optional hard disk mounting kit allows installing any 1" drive on the back of the card
- notes
- 32 bit expansion bus for the EGS 110/24 graphics board
- if the EGS 110/24 is installed no place remains for the hard disk mounting kit
- 68000 fallback mode switchable either by software or jumper
- in 68000 fallback mode RAM and SCSI is also switched off
- Kickstart remapping
- jumper settings
- rev 3
J5
ON
OFF
ONJ6
OFF
ON
ONJ11
OFF
ON
OFFCN8
2-3
OFF
1-2- board type
- 25 MHz
- 40 MHz
- 50 MHzJ2 - 68000 fallback mode: OFF - enable J3 - MMU: ON - disable J9 - autoboot ROM: OFF - disable J12 - bank 1-2 memory address: ON - Zorro II address space, OFF - 0x01000000 J14 - SCSI drive: OFF - connected CN6 - HDD LED CN16 - FPU clock: 2-3 - uses CPU clock J4
ONJ7, J8, J10, J13, J15
OFFCN7, CN15
1-2CN14
2-3
- reserved - rev 4 (additional jumpers to rev 3)
J16 - DTACK pull-up for old A2000s: ON - enable CN15 - autoboot ROM version: 1-2 - v4.5; 2-3 - before v4.5 CN17
2-3
1-2-3
- 25 MHz, 50 MHz
- 40 MHz
Rev 3, front side
Rev 3, front side
Rev 3, back side
Rev 4, front side
Rev 4, front side
Rev 4, back side
- GForce2030-920914.dms
install disk (14.9.92)
gvpscsi.device v4.5
207 kB - GForce2030-921002.dms
install disk (2.10.92)
gvpscsi.device v4.13
406 kB - GForce2030.dms
install disk (13.9.90)
gvpscsi.device v3.7
343 kB - amiga.html#gvp
Ralph Babel
SCSI ROM image
gvpscsi.device v4.15
16 kB - combo030.dms
GVP-M
install disk
379 kB
Advert (DE)
1991-06
Advert (US)
1992-02
Advert (US)
1992-03
Advert (FR)
1992-05
Advert (US)
1992-09
Advert (DE)
1992-10
Advert (DE)
1993-02
Advert (US)
1993-06
Advert (US)
1993-11
Advert (US)
1998-05
Manufacturer Great Valley Products, USA | Date 1992 | Amiga A3000 | Interface CPU slot |
- processor
- 68040 @ 28 / 33 MHz
- MMU and cache disable jumpers
- memory
- eight 68 pin SIMM sockets for up to 8 MB RAM
- supports only special 1 MB non-multiplexed 40 ns GVP SIMMs
- accepts SIMMs in 1 MB increments
- burst RAM access can be enabled only when 4 or 8 MB RAM is installed
- fully autoconfiguring
- supports DMA to any A3000 peripheral
- notes
- software switchable 68030 fallback mode
- jumper settings
| JP10 OFF ON |
JP26 OFF OFF |
JP27 OFF ON |
JP28 ON OFF |
JP29 OFF OFF |
JP30 OFF ON |
JP31 ON OFF |
JP32 OFF OFF |
JP33 OFF ON |
- burst mode - enabled - disabled |
| JP1 - | MMU: OFF - enabled |
| JP2 - | cache: ON - enabled |
| JP22 - | CPU clock: ON - asynchronous, OFF - synchronous |
| JP23 - | CPU: ON - 68030, OFF - 68040 |
| JP24, JP25 - | RAM: ON - disabled |
| JP4, JP6, JP13-16, JP18, JP20 ON | JP3, JP5, JP7, JP9, JP12, JP19, JP21, CN5 OFF | CN3, CN4 2-3 | - reserved |
front side
front side
front side
back side
- GForce3040.dms
install disk v1.03 (21.1.92)
360 kB
Advert (US)
1992-01
Manufacturer Great Valley Products, USA | Date 1992 | Amiga A2000 | Interface CPU slot | Autoconfig ID 2017 / 11,255 |
- processor
- 68040 @ 33 MHz
- memory
- four 64 pin SIMM sockets accept 64 MB RAM
- supports only special 4 or 16 MB GVP SIMMs
- SIMM sizes cannot be mixed
- 040 burst mode requires all four sockets to be filled up
- Kickstart remapping
- SCSI 2 DMA controller
- not Fast SCSI 2 - the same electronic as the GVP Series II controllers
- no termination power is fed to the external SCSI connector - active termination must be used
- 50 pin internal SCSI header
- DB25 external connector
- RDB compatible
- supported by Linux and NetBSD
- I/O
- RS232 compatible 9 pin buffered serial port
- 614140 bps max transfer speed
- Centronics parallel port
- selectable IBM / Amiga compatible mode
- notes
- 32 bit expansion bus for the EGS 110/24 graphics board
- jumper settings
| J4 - | SCSI drive: OFF - connected |
| J5 - | autoboot ROM: OFF - disable |
| J7 - | MMU: ON - disable |
| J20 - | SIMM size: ON - 4 MB, OFF - 16 MB |
| J22 - | burst mode: OFF - enable |
| J26 - | DTACK pull-up for old A2000s: ON - enable |
| CN9 - | parallel port mode: 1-2 - Amiga, 2-3 - IBM |
| J10, J16, J21, J24, J27 ON | J2, J3, J8, J15, J17, J18, J19, CN19 OFF | CN12, CN20 1-2 | CN11 2-3 | - reserved |
front side
front side
back side
- GForce2040-140.dms
install disk v1.40 (18.2.93)
410 kB - GForce2040.bin
ROM image (1994)
32 kB - amiga.html#gvp
Ralph Babel
SCSI ROM image
gvpscsi.device v4.15
16 kB - combo040.dms
GVP-M
install disk v1.51
415 kB
Advert (US)
1992-09
Advert (DE)
1993-02
Advert (US)
1993-06
Advert (US)
1993-11
Advert (US)
1994-04
Manufacturer Great Valley Products, USA | Date 1994 | Amiga A4000 | Interface CPU slot |
- processor
- 68040 @ 33 / 40 MHz
- memory
- two 64 pin SIMM sockets accept 32 MB RAM
- supports only special 1, 4 or 16 MB GVP SIMMs
- optional RAM board
- six additional SIMM sockets accept 96 MB RAM
- gives a total of 128 MB RAM
- one 4 MB SIMM is factory installed
- optional Fast SCSI 2 module
- max 10 MB/s transfer speed
- note
- the optional RAM and SCSI modules do not fit into A3000 / A3000T / A4000T
front side
without RAM, front side
with RAM, front side
front side
back side
Memory module, front side
Board with Memory module, front side
- a4040.dms
GVP-M
install disk
387 kB
Advert (US)
1994-04
Advert (AU)
1994-07